Home > Uncategorized > Routing does not snap to Pins and Vias in Allegro PCB Design

Routing does not snap to Pins and Vias in Allegro PCB Design

Routing does not snap to Pins and Vias in Allegro PCB Design

by starredreviews.com

I am trying to route Allegro. However, when I try to route, the start of the route does not snap to the Pin. Instead it arbitrarily starts from the place where I start the routing. Any way to turn off this behavior ?

– The solution is this

Click on the route. Now the key to the solution is that you need to be able to select the Pins or the Vias.

Go to the Find Tab Next to the Options. Make sure that the Pins and Vias are selected.

 

If you do this, then, while routing , it will snap to the Pins and the Vias. Issue resolved ?

 

 

Categories: Uncategorized Tags:
  1. Ruskan
    June 22nd, 2011 at 12:04 | #1

    I think it happens because the settings are stored in a .cfg file. When you install the Allegro in a new machine it gest to a default state. And the issue comes up. This should be helpful for the beginners as well as the experirnced persons if they ever get into trouble.

  2. Alex
    October 29th, 2012 at 09:04 | #2

    This helped me a lot thank a ton.